Click Stick V3 Instructions

When you receive your Click-Stick V3 it sould look like this with 2 bands installed and a string attached under the bands on the back side. (this string is there to assist you in pulling the bands down and exposing the locking tab underneath them)

You will start by removing the rear cap screw and turning the rear cap counter clockwise about an 8th of a turn and removing it. 

You will now remove the factory button by bending the small metal tabs out of the way. the straighten then back up to accept the Click-Stick screws.

You will now use the string to pull the bands down exposing the locking tab on the Click-Stick base. that tab end should be installed into the rear cap first and once it snaps in place you can rotate the top on the Click-Stick base into place. 

Now use the supplied screws to lock the Click-Stick base in place and hold the button in alignment with the holes. 

Reattach in reverse manner. I personally leave the small screw out that holds the rear cap on as the 8th turn lock is sufficient.